| YetiCam is proud
to offer YetiCam complete kits for the popular Sony DSC-P41 and
Sony DSC-S600 models. Our kits are the finest kits available and
our professionally machined to .001" tolerance. This tolerance
is so tight that pieces actually "snap" into place. If you are
looking for a professional looking unit with minimal effort,
then the YetiCam complete kit is for you! |
|
Camera is
not included.
Sample Kit Picture |
|

-
Mossy Oak Pelican 1040 with professionally
machined holes for lens hole, flash hole, and pipe through
holes
-
Pelican 1040 case liner
-
Professionally machined PVC pipe. The inside
of the pipe has been machined to allow Python Cable to pass
through easier.
-
Pelican 1040 lid foam that should be used for
flash gasket (use hot water on the outside of the case to
help remove foam).
-
1 piece of glass to cover lens hole.
-
1 piece of glass to cover the flash hole.
-
Professionally machined control board
mounting bracket. This bracket insures that the distance to
the Fresnel lens is exactly what it needs to be!
-
YetiCam control board.
-
Four conductor cable for connecting camera to
control board.
-
YetiCam DIP switch sticker.
-
Fresnel lens
-
9 volt battery holder with switch and quick
connector.
-
Velcro for attaching battery holder to case.
-
Double sided stick tape for attaching Fresnel
lens to board mounting bracket.
-
Cable to connect camera to board (type
depends on camera i.e. servo, stereo jack, etc.)
-
Aluminum shelf for camera where required.
-
Snorkel for extending camera lens where
required.
|
|
|
|
|
|
|